California Trimmer Mower
Maintenance Manual
41
Heavy Duty & Commercial
Roller Assembly – (Continued)
Step 4
Install bolts, lock washers and washers. Tighten the bolts on both ends at this time.
Make sure the roller spins freely. If the roller does not spin freely one or both of the bearings may be
“locked” up on the shoulder of the roller shaft. Using a hammer, tap one or both sides of the roller shaft
until the roller spins freely.
Step 5
Place the sprocket spacer over the remaining three holes.
Step 6
Install the 30 tooth sprocket using bolts, lock washer and washers. Try the center the sprocket as much
as possible.
