HOVER MOWER OPERATOR’S MANUAL
Evergreen Turf Equipment
• 1028 4
th
St. SW, Bldg. A
• Auburn, Washington 98001 • caltrimmer.com
Page 2
Introduction
Read this information carefully to learn how to operate
and maintain your product properly and to avoid injury
and product damage. You are responsible for operating
the product properly and safely.
Important:
This engine is not equipped with a spark
arrester muffler. It is a violation of California Public
Resource Code Section 4442 to use or operate the
engine on any forest-covered, brush-covered, or grass-
covered land. Other states or federal areas may have
similar laws. This spark ignition system complies with
Canadian ICES-002.
The enclosed Engine Owner's Manual is supplied for
information regarding the US Environmental Protection
Agency (EPA) and the California Emission Control
Regulation of emission systems, maintenance, and
warranty. Replacements may be ordered through the
engine manufacturer.
You may contact
Evergreen Turf Equipment
directly for
product and accessory information, help finding a dealer,
or to register your product. Whenever you need service,
genuine California Trimmer parts, or additional
information, please contact our Customer Service and
have the model and serial numbers of your product
ready. They are located on the decal on the rear of the
unit as shown in this photo:
Write the numbers in the following space provided.
Model Number: ____________________________
Serial Number: ____________________________
You may complete and mail the enclosed product
registration card, or you can register on-line at:
Should you require warranty service, take a copy of your
sales receipt and a copy of your product registration card
to your servicing dealer.
Carton Contents
- California Trimmer Hover Mower
- California Trimmer Product Registration Card
-
Engine Owner’s Manual / Emission System Warranty
- Lower Handle Assembly (with handle stand)
- Upper Handle Assembly (including throttle cable,
engine stop lever, and on/off switch)
Key Components
The image below identifies key components of the Hover
Mower so take the time to familiarize yourself with them
and their function.
Assembly & Set-up
The unit has been carefully pre-assembled with
adjustments and quality inspections performed by a
team of trained technicians who take great pride in their
work. For packaging and shipment, there are
components that need installation.
When instructions
refer to the left or right side of the unit, it means as
standing behind at the normal operation position.
Tools Required
Regular or needle-nose pliers, medium adjustable
wrench, and 1/2" wrench (for adjusting cutting height
and replacing blades
– see page 7).
