7
First start up
1)
Open the high and low pressure refrigerant valves.
2)
Open water switch and fill the hot water cylinder with water.
3)
Make sure that the cylinder is filled with water.
4)
Make sure that the temperature sensor is in the lower temperature
probe pocket of the cylinder.
5)
Connect the power cable.
6)
Turn the system on at the control panel.
7)
The Controller is pre-set for Cylinder heating at 60°C. All you have to
do is set the clock and if required, the timer
(see Clock setting & Timer
setting page 11 & 12).
