154
Proprietary Information: Not for use or disclosure except by written agreement with Calix.
© Calix. All Rights Reserved.
e.
Click
Advanced
, and then configure the Advanced setting on the bonding group
member's xDSL port:
PTM Override (auto is not allowed)
Note:
PhyR is not supported on bonded lines. If PhyR is enabled by the user, it will be
automatically disabled by the hardware.
f.
In the menu, click
Apply
for the changes to take effect.
g.
Repeat Step 2 to configure the second xDSL port that will be a member of the
bonding group.
3.
In the Navigation Tree, click the VDSL2 card which is intended to have the bonding
group.
4.
In the Work Area, click
Provisioining
>
Create
>
XDSL Group
.
5.
In the Create DSL Bonding Group dialog, do the following:
a.
In the Name box, enter a descriptive name for the bonding group.
b.
In the Admin State list, select whether to enable the bonding group.
c.
In the Subscriber ID box, enter information that is unique to the subscriber, such as
an account number or address.
d.
In the Description box, enter further information that would be helpful to identify
the bonding group.
e.
In the IGMP Immediate Leave list, select whether a multicast stream is dropped as
soon as a Leave is received.
Note:
This parameter is also set in the IGMP profile that is associated with a VLAN.
Setting the parameter at the bonding group level overrides the setting in the IGMP
profile.
f.
In the DS Min Rate and US Min Rate boxes, enter values that are used to generate
low-rate alarms.
g.
In the Security Profile list, select the name of the existing security profile to use for
the bonding group.
h.
In the DSCP/IP Precedence Map list, select the name of the DSCP or IP Precedence
profile to use for mapping Layer 3 priority values to P-bits.
i.
In the Member 1 list, select the xDSL port to assign as the first member of a bonding
group.
j.
In the Member 2 list, select the xDSL port to assign as the second member of a
bonding group.
Note:
The xDSL ports that you want to add to a bonding group at the time of creation
must first be configured with the valid combination of service type and PTM Override
attributes.
