174
Proprietary Information: Not for use or disclosure except by written agreement with Calix.
© Calix. All Rights Reserved.
Locally via the EWI:
On the Navigation Tree, click the
E7, E5-48 or E3-48C
.
In the Work Area, click
Profiles
>
Service
>
H.248 GW
>
Profiles
.
2.
In the menu, click
Create
.
3.
Reference the table above to configure the parameters.
4.
Click
Create
.
For CLI:
create h248-gw-profile <p-name> [rtp-base-port|pri-gw-controller|pri-switch-
type|sec-gw-controller|sec-switch-type|term-prefix|ephemeral-term-id|esa-
mode|rtp-codec|packet-rate|country-code]
Creating an H.248 Gateway
This topic describes how to create a profile that specifies the H.248 gateway properties for
the VDSL2 H.248 gateway services.
Parameters
You can provision the following parameters for H.248 gateway:
Parameter
Description
Valid Options
Name*
Name of the H.248 gateway.
A 31-character text string
Admin State
Administrative status for the gateway.
enabled ‡, disabled
H.248 Gateway
Profile*
Name of the H.248 gateway profile.
text string
IP Host*
Name of the line card IP Host.
text string
*Required field
‡Default
To create an H.248 Gateway
1.
In the Navigation Tree, click the
E-Series
on which to create an H.248 Gateway.
2.
In the Work Area, click
H.248 Gateway
, and then click
Create
.
3.
Reference the table above to configure the parameters.
4.
Click
Create
.
For CLI:
create h248-gw <shelf/card/gw-name> h248-gw-profile <p-name> ip-host <h-
name> [admin-state]
remove h248-gw-svc from-pots-port <vdsl-port>