30
Proprietary Information: Not for use or disclosure except by written agreement with Calix.
© Calix. All Rights Reserved.
For an RSTP network, Calix recommends setting the following parameters as shown:
The VLAN IGMP Mode = snoop-suppress or proxy
The IGMP profile Router Learning Mode = static-dynamic
The IGMP profile Router Solicit On Topology Change = Y (enabled)
The interface NOT be designated as a static router port through the VLAN
membership.
The Interface Quality Audit (IQA) function periodically checks the number of File Check
Sequence (FCS) errors received as a percentage of total frames received on an interface.
An interface that exceeds the provisioned thresholds can be set to generate an alarm,
switch traffic to an alternate path, or force the interface to an OOS state where operator
intervention is required to bring the interface to an operational state by manually
disabling the interface, and then re-enabling the interface.
Before starting
Before starting the configuration process, check that the following conditions are met:
The policy map that you want to associate to the E-Series Ethernet port interface is
already created.
Parameters
You can provision the following parameters for Ethernet interfaces:
Parameter
Description
Valid Options
Name
*
Name of LAG interface or associated Ethernet port (card/Ethernet port).
(
Note:
This is a case-sensitive string.)
String 31 characters
Role*
Role of E-Series Ethernet port interface.
trunk
and
edge
are supported on E7-2 standalone, E7 modular
chassis controller, and E7-20 SCP cards.
access
is supported on E7-2 standalone, E7 modular chassis
controller, E7 modular chassis expansion cards, and E7-20
linecards.
See the rules and restrictions for each role in the above paragraphs.
trunk
edge
access
E7-2, E7 Modular Chassis
Controller, and E7-20 SCP
cards:
10G = trunk ‡
1G = edge ‡
E7-20 and E7 Modular
Chassis Expansion:
10G = access ‡
1G = access ‡
Default (LAG) = NA
Admin State
Service state of E-Series port interface. Select whether the interface is
in service.
Note:
Before you can assign a port to a LAG interface, you must disable
the port's default associated interface. When a port is assigned to a
LAG, the LAG interface provisioning (for example, VLAN membership)
applies to the port.
enabled ‡
disabled
Description
Descriptive name for the interface.
String 31 characters
