32
Proprietary Information: Not for use or disclosure except by written agreement with Calix.
.
Additional Comments
Once your units LED turns BLUE, you are connected to the upstream WAN modem.
At start-up, Wi-Fi radios are defaulted to on.
To configure your BLAST device, connect an Ethernet cable between your PC and the
LAN port of your unit and enter the default IP Address of the device (192.168.1.1) into
your browser.
Wi-Fi radios can be configured using the default settings:
SSID: Printed on the product label in the gift box. (CXNKxxxxxxxx)
Number of radios: 2 (2.4 GHz and 5 GHz)
Wi-Fi Protocol supported: 802.11a/b/n/g/ac/ax
Credentials: Login and password printed on the product label in the gift box.
LED States - Power Off & Boot-up
Note:
For all LED sequences, the BLAST u4/u4m incorporate a single LED located on the
interface side of the unit.
Power Off and Boot-up
Description
Colors
Indication
OFF
Power is Off
The unit has not been turned on
or
There is no power to the unit
or
Any auxiliary battery has been discharged and can
no longer power the unit.
Off
Booting Up, SW Upgrade in Process
Unit is in the process of booting up or
services/software is being upgraded
Flashing ever 1 second assuming software can
control the LED
Off & Cyan
Cycles @
1000 msec
Boot-up Failure
Unit boot-up has failed (assuming software can
control the LED).
Off & Red
Cycles @
800 msec
Summary of Contents for GigaSpire BLAST U4
Page 1: ...GigaSpire BLAST Installation Guide Model u4 u4m June 2021 Part 220 01192 Rev 10...
Page 2: ......
Page 28: ...28 Proprietary Information Not for use or disclosure except by written agreement with Calix...
Page 36: ...36 Proprietary Information Not for use or disclosure except by written agreement with Calix...
