44
Proprietary Information: Not for use or disclosure except by written agreement with Calix.
© 2001-2008 Calix. All Rights Reserved.
To close a cabinet door
1.
Push up the wind latch to release the brace.
2.
Swing the door closed. Lift up on the handle and push the door against the cabinet.
3.
While holding the door firmly closed, push down on the handle to engage the door latch.
4.
Push the handle inward to engage it into the handle housing.
Battery Compartment Doors
The cabinet's front and rear battery compartments are equipped with removable access
doors. Each battery compartment door is secured at the top by 7/16-inch hex bolts that can
only be accessed when the cabinet door above it is open, thus preventing unauthorized
access.
To open a battery compartment door
1.
Open the cabinet door above the battery compartment door.
2.
Using a 7/16-inch nut driver, remove the bolts at the top of the battery compartment
door. Set aside the bolts to later re-attach the door.
3.
Tilt and pull the door panel forward, away from the cabinet.
4.
To completely remove the door, disconnect the ground strap using a 3/8-inch hex nut
driver.
To close a battery compartment door
1.
Re-attach the ground strap to the door (if removed) using a 3/8-inch hex nut driver.
2.
Insert the tabs on the bottom of the door into the notches at the base of the
compartment, then tilt and push the door panel closed. Some force may be required.
3.
Insert the bolts (removed previously) through the matching holes in the door and cabinet
and tighten using a 7/16-inch nut driver.
