User Guide
Table 7 Ethernet RJ-45 Connector Wiring Pattern
Pin
Color
Signal
Pin
Color
Signal
1
Orange/White TX_D1+
5
Blue/White
BI_D3-
2
Orange
TX_D1-
6
Green
RX_D2-
3
Green/White
RX_D2+
7
Brown/White BI_D4+
4
Blue
BI_D3+
8
Brown
BI_D4-
3.6
Verifying the Installation
Check LED states to verify ONT status. Services are not available until the
ONT is ranged and provisioned in the PON network. If services must be verified
at the time of installation, refer to Section 3.6.2 Verifying Services on page
11 for additional instructions.
3.6.1
Activating the ONT
Once the ONT installation is complete, follow the procedure below for verifying
ONT status. Figures below shows the typical status LED display after the ONT
boot sequence is complete.
Figure 4 ONT Has not Been Provisioned
G102380A
Figure 5 ONT Has Already Been Provisioned
G102381A
•
Verify that the
POWER
LED light is green, indicating that local power level
is good
10
220-00602 R10 | October, 2013