BA-ORTHO_EN V2.0
Seite: 13 von 19
Program-Mode:
The „SET3-Button“ allows access to the programs. By repeated actuation the Programdisplay start to
moving from top downstairs. After program 8 all LED at program Display are shining. Now the RS232
Mode is activated. After this the Programmode stops and the normal Mode is activated.
By pushing the
„START-Button“ the programm will start.
the programs1-7 are fixed programs. The steps are shown by clicking every step.
Program 8 is for general purpose. You can create your own program.
After the program is finished you can restart it by pushing the
„START-Button“.
Pulsmonitoring with Polar chestbelt is activated by pushing „Puls-Button“.
6.5 Reverse Mode
If the running surface is stoped you can change the running direction by pushing the „STOP-Button“ and
then the
„Minus-Button”. If the running direction is on reverse mode the Speed Display is all the time blinking.
To change the running direction in normal Mode push „STOP-Button“ if the running surface is stoped push it
again and then push the “Plus-Button”. If the Speed Display is not blinking any more the running direction is
for normal use.
NOTE: Liability voids in case of potential back injuries caused by the handrail in reverse mode.
Devices with adjustable inclination the usage of the treadmill to walk downhill is only possible partly. The
maximum speed is heavily dependent on the set inclination percentage and the weight of the user.
