Locate a suitable power outlet:
Choose a power outlet that is close to
where you plan to place the camera unit.
Connect the camera to the power outlet:
Plug the charging cable into
the camera unit and the power adapter into the power outlet.
Turn on the power:
Wait for about 2 seconds until the power indicator
light turns on. This means that the camera unit is working.
Place the camera unit:
Choose a suitable location for the camera unit.
You may want to test a few different locations to find the best spot.
Power on the display unit:
Long Press the Power Button to turn on the
display unit. Confirm the connection is established by checking the
signal bars, the picture will show on the display unit.
Please refer to the
operation guide at page 10
, if you need to pair the
camera with the display unit.
Use the monitor:
Once the monitor is set up, you can start using it to
keep an eye on your baby. Remember to follow this user manual for
safe use of the device.
1.
2.
3.
4.
5.
6.
7.
Camera
Quick Setup
4
IR Light Sensor
Camera Lens
MicroSD Card Slot
Pairing Button
Microphone
Signal Antenna
MicroSD Charging Port
Power Indicator
Thermometer
