68
1002595 ISSUE 5 M172 VARIHEAT
VARIHEAT AA SYSTEM OWNER INSTALLATION MANUAL
8.0 WARRANTY CONDITIONS
One year manufacturer’s warranty is valid from the date of commissioning or
18 months from delivery, whichever is sooner.
Where commissioning is provided in the UK and Ireland, this must be carried
out by factory trained and approved personnel.
The following exclusions apply to the Warranty given by Dantherm Ltd. No
claims will be accepted if :
1. The heat pump is installed in any way that is not in accordance with the
current procedures as defined by Dantherm Ltd.
2. The heat pump has not been maintained in accordance with service
requirements in section 4.1 Regular Planned Maintenance.
3. The heat pump has been worked upon or is adjusted by anyone other
than a person authorised to do so by Dantherm Ltd.
4. The heat pump is incorrectly sized for the application.
5. The water flow through the machine is outside the specified limits.
6. The water pH level and/or chemical balance is outside the following limits:
7. The heat pump has suffered frost damage.
8. The electrical supply is insufficient or in any way incorrect.
9. The fan amps and duct pressure are outside the specified limits.
10. The air flow to and from the machine is outside the specified limits.
11. Corrosion is present due to poor air quality that has not been attended to.
If in doubt or if advice is required please contact the Dantherm Group
UK Service Department by calling 01621 856611 (option 4) or emailing
service.department@dantherm.com
Note:
The Reply Paid Warranty Registration Card must be returned, to ensure
that the correct warranty is given. If you do not find a Registration Card with
your heat pump please contact the Dantherm Group UK Service Department
giving your name, address and serial number of your heat pump. A card will be
sent to you for completion.
Please give
MODEL NUMBER
and
SERIAL NUMBER
of your heat pump when
making technical or service enquiries. This will assist in correct diagnosis and
ensure service can be provided with the minimum delay.
Acidity pH
pH
7.2 - 7.8
Total Alkalinity, as CaCO3
ppm
80 - 120
Total Hardness, as CaCO3
ppm
150 - 250
Total Dissolved Solids
ppm
1000
Maximum Salt Content
ppm
8000
Free Chlorine Range
ppm
1 - 2 Domestic
Free Chlorine Range
ppm
3 - 6 Commercial
Superchlorination
max
30ppm for 24 hrs
Bromine
ppm
2 - 5
Baquacil
ppm
25 - 50
Ozone
ppm
0.9 Max
Maximum Copper Content
ppm
1
Aquamatic Ionic Purifier
ppm
2 Max
Summary of Contents for Variheat AA1200
Page 2: ......
Page 69: ...69 1002595 ISSUE 5 M172 VARIHEAT...
Page 70: ...70 1002595 ISSUE 5 M172 VARIHEAT...
