2013 Portable Spa
LTR20131000, Rev. E
Pr
eparing f
or
Your Ne
w P
or
tab
le Spa
www.calspas.com
11
Prime the pump .
5 .
Turn on power to the spa .
4 .
Install the fi lter into the fi lter canister.
6 .
Make sure the fi lter has soaked at least 30 minutes
before you install it.
Your spa will perform a self-diagnostic check and go into
priming mode. When the control panel displays
PR
, do the
following:
Press the JETS button to turn on the pump and let it
a.
run for 10 seconds. The pump should be running in
low speed.
Press the JETS buttons again and let the pump run in
b.
high speed for 10 seconds.
Press the JETS button again to turn off the pump. The
c.
pump should be left off for 10 to 15 seconds.
Repeat steps a through c until water is fl owing through
d.
all the jets and all air is removed from the plumbing.
Let the spa heat up .
7 .
When the spa has fi nished priming, the heater will activate.
Put the cover on and let the spa run for two hours.
Adjust water chemistry .
8 .
After the spa has run for two hours, test and adjust the water chemistry. See the section on page 31 for
instructions on water clarity.
When the spa is fi lled to the correct level, turn on the
power at the GFCI breaker. (Ensure that the 120V spas are
connected to the proper electrical outlet.)
If spa fails to prime, there could be an air pocket at the suction side of the pump. Follow the priming instructions
on page 12 using the bleeder valve.
Summary of Contents for F1418
Page 1: ...LTR20131000 Rev E 9 18 13...
