2013 Portable Spa
LTR20131000, Rev. E
Operating
Your Spa
www.calspas.com
17
9800 Electronic Control Operation
These instructions will describe features and options that your particular spa may not be equipped with.
Auxiliary Control Operation
The auxiliary control option is available with the
9800 control panel only. It is a small panel with
four buttons: JETS1, JETS2, LIGHT, and OPTION. It
conveniently puts the control of several spa functions
at your fi ngertips without having to get up.
Initial Start up
When fi rst powered up, your spa will perform a self-
diagnostic check and go into priming mode. When
the control panel displays
PR
, IMMEDIATELY do the
following:
Press the
1.
JETS 1
button to turn
on the pump and let it run for 10
seconds. The pump should be
running in low speed.
Press the
2.
JETS 1
buttons again and let the pump
run in high speed for 10 seconds.
Press the
3.
JETS 1
button again to turn off the
pump. The pump should be left in the off position
for 10 to 15 seconds.
Repeat steps 1 through 3 until water is fl owing
4.
through all the jets and all air is removed from
the plumbing.
When the spa has fi nished priming, the heater will
be activated and the water temperature will be
maintained in standard mode. The spa will heat to
100°F (37.5°C) at start up until the set temperature
is changed as described below.
Temperature Adjustment
(Range 80°F to 104°F, 26°C to 40°C)
The start-up temperature is set at 100°F (37.5°C).
The last measured temperature is constantly
displayed on the control panel. Note that the
last measured spa temperature is displayed. The
displayed temperature will be updated when the
pump has been running for at least two minutes.
Press the “UP” or “DOWN” buttons once to display the
set temperature. Each time either button is pressed
again, the set temperature will increase or decrease
depending on which button is pressed. After three
seconds, the control panel will automatically display
the last measured spa temperature.
Summary of Contents for F1418
Page 1: ...LTR20131000 Rev E 9 18 13...
