65240
ISO Commanded Address
126208
NMEA Request/Command Group Function
5.3.2
Field programmability of the instance fields
NCP support field programmability of all the system and device instances fields
within NAME entity.
This can be done with PGN 126208 Command Group Function.
5.3.3
Load Equivalency Number
Low power – 126mA at 12 VDC (3 LEN) from NMEA 2000 bus.
NMEA 0183
5.4
The NMEA Connect Plus has two RS485 interfaces to be used as NMEA 0183 ports,
whereby two wires are used to transmit the NMEA data.
Both baud rate 4800 and 38400 bauds can be used. The default value is 4800 bauds
but it can be changed via the Webserver.
The NMEA0183 ports can be configured either as input or output (Only one port can
be configured as input). By default, Port 1 is configured as input and Port 2 as output.
The NMEA0183 port, receives wind data from the ULTRASONIC wired and exports it
to an NMEA 2000 network and Bluetooth interface. Moreover, it can also send wind
data via WIFI when used as WIFI repeater.
When the NCP is used on a NMEA 0183 network, the cable with end free wires
should be connected through the unit (follow the instructions in section 6.3).
Keep in mind that if the unit is connected to an
NMEA 2000 network, you do not
need an extra power connection. Otherwise, you must power the device using the
dedicated VCC input or the USB power.
5.4.1
NMEA 0183 sentences
NCP is able to receive/transmit the following wind sentence:
$IIMWV,XX,R,XX.XX,N,A*CR\r\n
WIFI NMEA 0183 server
5.5
Models with Wi‐Fi have a NMEA 0183 Wi‐Fi server, that allows sending the input
wind data via Wi‐Fi, using a TCP socket and sending it with the format of the NMEA
0183 sentences (see section 7.3 to configure the TCP port).