14
2
Basic Operation Guide
2.1 Startup & Shutdown
Please make sure all the connections
are done properly before you power on
the unit. Proper startup and shutdown
are crucial to expending the life of your
device.
2.1.1 Startup
1. Connect the output display device to
the VGA/HDMI interface of the DVR.
2. Connect with the mouse and power.
The device will boot and the power
LED would turn blue.
3. A WIZARD window will pop up (you
should select the display language
the first time you use the DVR). Refer
to 3.1 Startup Wizard for details.
2.1.2 Shutdown
You can power off the device by using
remote controller or mouse.
By remote controller:
1. Press Power button. This will take
you to a shutdown window. The unit
will power off after a while by clicking
“OK” button.
2. Disconnect the power.
By mouse:
1. Click Start
Shutdown to pop
up the Shutdown window. Select
“Shutdown” in the window. The unit
will power off after a while by clicking
“OK” button.
2. 2 Disconnect the power.
2.2 Remote Controller
1. It uses two AAA size batteries.
2. Open the battery cover of the
remote controller.
3. Place batteries. Please take care the
polarity (+ and -).
4. Replace the battery cover.
Key points to check in case the remote
doesn’t work.
1. Check batteries polarity.
2. Check the remaining charge in the
batteries.
3. Check IR controller sensor for any
masking.
If it still doesn’t work, please change a
new remote controller to try, or contact
your dealers. You can just turn the IR
sensor of the remote controller towards
the IR receiver of the DVR to control
it when you are controlling multiple
devices by remote controller.
There are two kinds of remote controller.
The interface of remote controller is
shown as below.
Summary of Contents for CS-DR8900
Page 68: ...68...
