23
4
Camera Management
4.1 Signal Access Set
Click Start
Settings
Camera
Manage Camera
Signal Access Set to
go to the interface as shown below.
There are two types of analog signals:
TVI and AHD. If the access signal is TVI,
you should check TVI in the following
interface to show the camera image
normally; if you check AHD, then there
will be no image or the image has no
color. The default selection of the
signal is Auto. If you check Auto, then
the image of the camera will be shown
normally regardless of the access signal
type.
4.2 Add/Edit Camera
4.2.1 Add Camera
The network of the DVR should be set
before adding IP camera (see 11.1.1 TCP/
IPv4 Configuration for details).
Refer to the pictures below. Click
Add
Camera
in the setup panel or
in the
top right corner of the preview window
to pop up the “Add Camera” window as
shown below. You can quickly add or add
the IP camera manually.
Quickly Add
Check the cameras and then click
“Add” to add cameras. Click to edit the
camera’s IP address, username and
password and so on. Click “Default
Password” to set the default username
and password of each camera.
Add Manually
Input the IP address, port, username
and password of the camera and
then select the protocol. Click “Test”
to test the effectiveness of the input
information and then click “Add” button
(you can input one camera’s information
or above such as IP address, username
and password before clicking “Add”
button). Click
to delete the camera.
Click “Default Password” to set the
default username and password of each
camera.
4.2.2 Edit Camera
Click “Edit Camera” in the setup panel to
go to the interface as shown below. Click
to view the live image of the camera
in the popup window. Click
to edit the
camera (see Add camera in 3.1Startup
Wizard for details). Click
to delete the
IP camera.
Summary of Contents for CS-DR8900
Page 68: ...68...
