52
11
Device Management
11.1 Network
Configuration
11.1.1 TCP/IPv4 Configuration
IP Address Settings
Click Start
Settings
Network
TCP/IPv4 to go to the following
interface. Check “Obtain an IP address
automatically” and “Obtain DNS
automatically” to get the IP address and
DNS automatically, or manually input
IP address, subnet mask, gateway,
preferred DNS and alternate DNS. Click
“Apply” to save the settings.
PPPoE Settings
In the above interface, check “Enable”
in “PPPoE Settings” and then input the
username and password obtained from
the dealer. Click “Apply” to save the
settings.
11.1.2 Port Configuration
Click Start
Settings
Network
Port to go to the interface as shown
below. Input the HTTP port, server port
and RTSP port of the DVR and then click
“Apply” to save the ports.
HTTP Port:
the default HTTP port of
the DVR is 80. The port number can
be changed to others like 81. The port
is mainly used to IE remote access. If
you want to access the DVR through
IE, you should input IP address plus
HTTP port in the IE address bar like
http://192.168.11.61:81.
Server Port:
the default server port
of the DVR is 6036. The server port
number can be changed as required.
The port is mainly used in network video
management system.
RTSP Port:
RTSP real-time stream
protocol can be used to control the
sending of real-time data. By media
player which supports the RTSP real-
time stream protocol, you can view the
live images synchronously. The default
RTSP port is 554 and it can be changed
as required.
n
Note:
The HTTP port and server
port of the DVR should be mapped
to the router before you access the
DVR via WAN.
Summary of Contents for CS-DR8900
Page 68: ...68...
