64
Q5. The DVR cannot add up to the
maximum number of IP cameras?
Take the 4 CH DVR as an example. Refer
to the picture below. The remaining
bandwidth should be larger than
the bandwidth of the IP camera you
want to add, or you would fail to add
the IP camera. You should lower the
added cameras’ bitrate to release the
bandwidth. It is recommended to add
cameras by “Quickly Add” for batch
adding.
Q6. The system cannot record,
why?
a.
Make sure the HDD was formatted
prior to use.
b.
The record schedule has not been set
in manual record mode. Please refer to
7.3.2 Record Schedule Configuration for
details.
c.
Maybe HDD is full and thus the
DVR is not able to record. Check HDD
information from Disk Management and
if required, please enable the recycle
function (please see 7.1.2 Advanced
Configuration for details).
d.
There is no disk but cameras in the
disk group, so please add at least one
disk to the group. Refer to 7.5.1 Storage
Mode Configuration for details.
e.
The HDD could have gone bad. Please
change another one.
Q7. Fail to access the DVR remotely
through IE.
a.
Please make sure the IE version is IE8
or above.
b.
Please check whether the PC has
enabled the firewall or installed the
antivirus software. Please try to access
the DVR again after you disable the
firewall and stop the antivirus software.
c.
Allow & block list may have been set in
Account and Authority setting. The PC
of which the IP address is in the block
list or out of the allow list cannot access
the DVR remotely.
Q8. ActiveX control cannot be
downloaded. How can I do?
a.
IE browser blocks ActiveX control.
Please do setup as per the steps
mentioned below.
1. Open IE browser. Click
Internet
Options.
2. Select Security
Custom Level.
Refer to Fig 8-1.
3. Enable all the sub options under
“ActiveX controls and plug-ins”. Refer
to Fig 8-2.
4. Then click “OK” to finish setup.
13 Appendix
Summary of Contents for CS-DR8900
Page 68: ...68...
