CAMBIUM NETWORKS
026v003
3
Safety and regulatory information
This section describes important safety and regulatory guidelines that must be observed by
personnel installing or operating ePMP equipment.
IMPORTANT SAFETY INFORMATION
Warning
To prevent loss of life or physical injury, observe the safety guidelines in this section.
Power lines
Exercise extreme care when working near power lines.
Working at heights
Exercise extreme care when working at heights.
Grounding and protective earth
Connectorized ePMP devices must be properly grounded to protect against lightning. It is the
user’s responsibility to install the equipment in accordance with national regulations. In the USA,
follow Section 810 of the
National Electric Code, ANSI/NFPA No.70-1984
(USA). In Canada, follow
Section 54 of the
Canadian Electrical Code
. These codes describe correct installation procedures
for grounding the outdoor unit, mast, lead-in wire and discharge unit, size of grounding
conductors and connection requirements for grounding electrodes. Other regulations may apply in
different countries and therefore it is recommended that installation be contracted to a
professional installer.
Powering down before servicing
Always power down and unplug the equipment before servicing.
Primary disconnect device
The ePMP power supply is the primary disconnect device.
External cables
Safety may be compromised if outdoor rated cables are not used for connections that will be
exposed to the outdoor environment.
RF exposure near the antenna
Strong radio frequency (RF) fields will be present close to the antenna when the transmitter is on.
Always turn off the power to the ePMP device before undertaking maintenance activities in front of
the antenna.
Minimum separation distances
Install the ePMP device so as to provide and maintain the minimum separation distances from all
persons.
The minimum separation distances for each frequency variant are specified in
Summary of Contents for ePMP 1000
