CAMBIUM NETWORKS
026v003
92
Table 67 ePMP 1000 wireless specifications (per frequency band)
Item
5 GHz
2.4 GHz
RF band (GHz)
4900 - 5980 MHz
2407 - 2472 MHz
Channel bandwidth
5 MHz, 10 MHz, 20 MHz or 40 MHz
5 MHz, 10 MHz, 20 MHz or 40
MHz
Typical antenna
gain
Connectorized antenna – 15 dBi
Integrated patch antenna – 13 dBi
Reflector dish antenna – 6 dBi
Connectorized antenna - 15 dBi
Integrated patch antenna - 11 dBi
Reflector dish antenna – 8 dBi
Antenna beamwidth
(Integrated)
24° azimuth, 12° elevation
24° azimuth, 12° elevation
Antenna beamwidth
(Relector dish)
10° azimuth, 25° elevation
10° azimuth, 28° elevation
REGULATORY LIMITS
The local regulator may restrict frequency usage and channel width and may limit the amount of
conducted or radiated transmitter power. For details of these restrictions, see
on page
Many countries impose EIRP limits (Allowed EIRP) on products operating in the bands used by the
ePMP Series. For example, in the 5 GHz and 2.4 GHz bands, these limits are calculated as follows:
In the 5.2 GHz (5250 MHz to 5350 MHz) and 5.4 GHz (5470 MHz to 5725 MHz) band, the EIRP
must not exceed the lesser of 30 dBm or (17 + 10 x Log Channel width in MHz) dBm.
In the 5.8 GHz band (5725 MHz to 5875 MHz), the EIRP must not exceed the lesser of 36 dBm or
(23 + 10 x Log Channel width in MHz) dBm.
In the 2.4 GHz band (2400 MHz to 2500 MHz), the EIRP must not exceed the lesser of 36 dBm or
(23 + 10 x Log Channel width in MHz) dBm.
Some countries (for example the USA) impose conducted power limits on products operating in
the 5 GHz and 2.4 GHz band.
CONFORMING TO THE LIMITS
Ensure the link is configured to conform to local regulatory requirements by configuring the
correct country code (located in the web management interface, under Configure => Radio). In the
following situations, the country code does not automatically prevent operation outside the
regulations:
When using connectorized APs with external antennas, the regulations may require the
maximum transmit power to be reduced. To ensure that regulatory requirements are met for
connectorized installations, see
Calculating maximum power level for connectorized units
. When operating in ETSI regions, it is required to enter a license key in the ePMP web
management interface to unlock valid country-specific frequencies. This key may be obtained
from
Summary of Contents for ePMP 1000
