CAMBIUM NETWORKS
026v003
197
Attribute
Meaning
Uplink Antenna
Selection
Uplink Antenna Selection specifies the antenna to be used in the uplink.
This parameter is specific to SMs registered to ePMP 2000 APs
configured with an optional Smart Antenna.
Auto: The AP decides which antenna to use (sector or Smart Antenna)
for uplink communications based on internal quality metrics.
Forced Sector Antenna: The AP uses the Sector Antenna for uplink
communications with SMs configured with this option
Forced Smart Antenna: The AP uses the smart antenna for uplink
communications with SMs configured with this option
Note
If the AP is configured with Uplink Antenna Selection set to Auto and
an SM is set to Forced Sector Antenna or Forced Smart Antenna, the
SM setting will be enforced.
If the AP is configured with Uplink Antenna Selection set to Forced
Sector Antenna or Forced Smart Antenna and a SM is set to a
conflicting Forced
setting, the AP’s setting will be enforced.
Scheduler
Uplink Max Rate
Configure the MCS (Modulation and Coding Scheme) rate beyond which
the radio’s scheduler should not exceed when transmitting data traffic
on the uplink. This is useful in situations where there is high variance
and unpredictability in the interference present in the environment
causing packet loss. Reducing the max rate to a lower MCS (than the
default MCS 15) may help in these situations. Reducing the Uplink Max
Rate will result in reduced throughput capacity of the SM in the uplink.
Not available when SM is in ePTP Slave or Standard WiFi mode.
Summary of Contents for ePMP 1000
