CAMBIUM NETWORKS
026v003
464
Notifications
This section contains notifications of compliance with the radio regulations that are enforced in
various regions.
2.4 GHZ, 5.4 GHZ REGULATORY COMPLIANCE
The ePMP complies with the regulations that are enforced in the USA, Canada and Europe. The
relevant notifications are specified in this section.
2.4 GHz, 5.1 GHz, 5.4 GHz FCC and IC notification
U.S. Federal Communication Commission (FCC) and Industry Canada (IC) Notification.
This device complies with part 15.407 of the US FCC Rules and Regulations and with RSS-210
Issue 8 of Industry Canada. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation. In Canada, users must be cautioned to
take note that high power radars are allocated as primary users (meaning they have priority) of
5250 – 5350 MHz and 5470 – 5725 MHz and these radars could cause interference and/or damage to
license-exempt local area networks (LELAN). To comply with FCC/IC RF exposure limits for general
population or uncontrolled exposure, the antenna(s) used for the ePMP transmitter must be
installed at a separation distance specified in
For the connectorized version of the product and in order to reduce potential radio interference to
other users, the antenna type and its gain must be so chosen that the equivalent isotropically
radiated power (EIRP) is not more than that permitted by the regulations. The transmitted power
must be reduced to achieve this requirement.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the US FCC Rules and with RSS-210 of Industry Canada. These limits are
designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio-frequency energy and, if not installed and
used in accordance with these instructions, may cause harmful interference to radio
communications. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment on and off, the user is encouraged
to correct the interference by one or more of the following measures:
Increase the separation between the affected equipment and the unit;
Connect the affected equipment to a power outlet on a different circuit from that which the
receiver is connected to;
Consult the dealer and/or experienced radio/TV technician for help.
FCC IDs and Industry Canada Certification Numbers are reproduced on the product label (
Summary of Contents for ePMP 1000
