CAMBIUM NETWORKS
026v003
141
Table 79 AP System attributes
Attribute
Meaning
General
Device Name
Specifies the name of the AP.
Webpage Auto
Update
Configure the interval for which the device retrieves system statistics for
display on the management interface. For example, if this setting is
configured to 5 seconds, the statistics and status parameters displayed
on the management interface will be refreshed every 5 seconds
(default).
Webpage Auto Update is a session only configuration change.
It is updated with the <Enter> key and is not savable when using the
save button.
Web Access
HTTP: Access to the device management GUI is conducted via HTTP.
HTTPS: Access to the device management GUI is conducted via HTTPS.
HTTP Port
If Web Service is set to HTTP, configure the port which the device uses
to service incoming HTTP requests for management GUI access.
HTTPS Port
If Web Service is set to HTTPS, configure the port which the device uses
to service incoming HTTPS requests for management GUI access.
SSH Access
Disabled: If the SSH port to the device is ‘Disabled’, access to the device
through SSH is not possible.
Enabled: If the SSH port to the device is ‘Enabled’, Cambium engineers
can access the device through SSH which enables them to login to the
radio and troubleshoot. SSH port is ‘Enabled’ by default.
Telnet Access
Disabled: CLI access via telnet is not allowed for the device.
Enabled: CLI access via telnet is allowed for the device.
MAC-Telnet Access
Disabled: Disables connections to the radio on the link layer via MAC
address from RouterOS or mactelnet-enabled devices.
Enabled: Enables connections to the radio on the link layer via MAC
address from RouterOS or mactelnet-enabled devices.
Note
In order to use MAC-Telnet the first time, the Administrator
account password must be changed on the GUI or the CLI. This
password can then be used for MAC-Telnet.
MAC-Telnet Protocol
MAC-Telnet: Use the MAC-Telnet subservice for access
MAC-SSH: Use the secured MAC-SSH subservice for access
Network Time Protocol
IP Assignment
Static: The device retrieves NTP time data from the servers configured
in fields NTP Server IP Address.
DHCP: The device retrieves NTP time data from the server IP issued via
a network DHCP server.
Preferred NTP Server Configure the primary NTP server IP addresses from which the device
will retrieve time and date information.
Summary of Contents for ePMP
