Chapter 5: Installation
235
Note
Cambium recommends assembling the antenna, attach the AP and cabling, and to
seal the RF connections before installing the unit at the deployment site.
1. Inventory the parts to ensure that you have them all before you begin. The full set of parts is shown
below.
Figure 89 :
AP antenna parts
2. Remove top plate from the antenna as shown in Antenna top plate.
Figure 90 :
Antenna top plate
3. Attach the antenna plate to the AP as shown in Attaching antenna plate to the AP.
Summary of Contents for PMP 450 Series
