Chapter 2: System hardware
72
Status information provided
LED
Color
when
active
SM / BHS in
“Operating”
Mode
SM / BHS in “Aiming” Mode
Note
Registering =
Solid green
Registered =
Solid yellow
changes from Green to Yellow.
O perat ing Mode
l
Scanning:
o
For hardware with 5 and 6 LEDs: If the SM/BHS is not registered to AP/BHM, then these LEDs
cycle on and off from left to right (SYN/1, SES/2 and GPS/3).
o
For hardware with 3 LEDs: If the SM/BHS is not registered to AP/BHM, then SES/SYN
session blinks yellow.
l
Ethernet Link:
o
For 450m AP, the MAIN LNK + ACT/5 LED is active when the Main port link is present and the AUX
LNK + ACT/4 LED is active when the Aux port link is present.
o
For 450/450i AP/BHM/BHS, the MAIN LNK/5 LED is lit continuously when the link is present.
l
Data Transfer:
o
For 450m AP, the MAIN LNK + ACT/5 LED flashes to indicate data transfer speed and activity on the
Main port and the AUX LNK + ACT/4 LED flashes to indicate data transfer speed and activity on the
Aux port.
o
For 450/450i AP/BHM, the ACT/4 LED flashes during data transfer.
o
For 450/450i SM/BHS, the ACT/4 LED flashes during data transfer.
o
For 450b 3 GHz and 5 GHz, the ETH LED flashes during data transfer.
o
For MicroPoP 5 GHz, the ETH LED flashes during data transfer.
Aiming Mode
For hardware with 5 and 6 LEDs, the 3 LEDs (SYN/1, SES/2, and GPS/3) are turned into a 3-position bar
graph. The more LEDs that are lit, the better the received power the module is seeing. For hardware with 3
LEDs, the SES/SYN LED indicates when the signal level is sufficient for normal operation. When the power
rises above this threshold, the LED color changes from yellow to green. The colors of the LEDs have no
particular meaning other than to assist is distinguishing one position from the next.
Summary of Contents for PMP 450 Series
