Release Notes
System Release 13.4
pmp-0979 - July 2015
Page
45 of
50
Products
Affected
Tracking
Description
Resolution
PTP 230
CPY-10730
BHS restarts due to error
“FeatureKeyDecrypt() Error
CRC mismatch”.
The problem has been resolved
in System Release 13.4.
PMP 100
CPY-10759
On occasion with a 900 AP,
the user may see a "this
function is not supported on
this platform!" message.
The problem has been resolved
in System Release 13.4.
PMP 450
AP
CPY-10780
Alternate frequency settings
are not displayed in AP
under DFS tab.
The problem has been resolved
in System Release 13.4.
PMP 430
SM
CPY-10813
Uplink 3X (64-QAM)
throughput degradation
observed with PMP 430 SM
on release 13.2 and
13.2.1.x.
The problem has been resolved
in System Release 13.4.
All
CPY-10859
Config file can be
downloaded without logging
into radio using direct link
This problem has been
resolved in System Release
13.4.
All
CPY-10881
Duplicate entries are
displayed for Bridge table
on AP, SM and BH
This problem has been
resolved in System Release
13.4.
All
CPY-10888
Config file upload changes
encryption setting from DES
to AES for AP if the config
file is downloaded from
same AP and it is configured
for DES.
This problem has been
resolved in System Release
13.4.
PMP 450
CPY-10903
CPY-10600
SM’s alignment tone
continues buzzing even after
restart of SM or
disconnection from AP
This problem has been
resolved in System Release
13.4.
All
CPY-10911
SM reboots when SM is in
NAT mode and NAT table is
filled with 2048 entries
This problem has been
resolved in System Release
13.4.
PTP 450
CPY-10986
BHM does not switch to
alternate frequency in case
of DFS event
This problem has been
resolved in System Release
13.4.
