Task 2: Configuring IP and Ethernet
interfaces
Chapter 2: Configuration and alignment
2-14
pmp-0050 (May 2012)
IP tab of the SM with NAT disabled
Figure 2
IP tab of the SM with NAT disabled
In the IP tab of an SM with NAT disabled, you may set the following parameters.
Table 4
SM with NAT disabled - IP attributes
Attribute
Meaning
LAN1 Network Interface
Configuration, IP Address
Enter the
non-routable
IP address to associate with the Ethernet connection
on this SM. (The default IP address from the factory is 169.254.1.1.) If you
set and then forget this parameter, then you must both
physically access the module.
use an override plug to electronically access the module configuration
parameters at 169.254.1.1. See
Overriding Forgotten IP Addresses or
on Page
Note or print the IP settings from this page. Ensure that you can
readily associate these IP settings both with the module and with the
other data that you store about the module.
LAN1 Network Interface
Configuration, Network
Accessibility
Specify whether the IP address of the SM should be visible to only a device
connected to the SM by Ethernet (
Local
) or should be visible to the AP as
well (
Public
).
LAN1 Network Interface
Configuration, Subnet Mask
Enter an appropriate subnet mask for the SM to communicate on the
network. The default subnet mask is 255.255.0.0.
LAN1 Network Interface
Configuration, Gateway IP
Address
Enter the appropriate gateway for the SM to communicate with the
network. The default gateway is 169.254.0.0.
Summary of Contents for PMP 450
