PMP 450 Configuration and User Guide
Task 2: Configuring IP and Ethernet
interfaces
pmp-0050 (May 2012)
2-23
Attribute
Meaning
Dynamic Learning
Specify whether the AP should (
Enabled
) or should not
(
Disabled
) add the VLAN IDs (VIDs) of upstream frames to the
VID table. (The AP passes frames with VIDs that are stored in
the table both upstream and downstream.) The default value is
Enabled
.
Allow Frame Types
Select the type of arriving frames that the AP should tag, using
the VID that is stored in the
Untagged Ingress VID
parameter.
The default value is
All Frames
.
VLAN Aging Timeout
Specify how long the AP should keep dynamically learned VIDs.
The range of values is 5 to 1440 (minutes). The default value is
25
(minutes).
VIDs that you enter for the
Management VID
and
VLAN
Membership
parameters do not time out.
Management VID
Enter the VID that the operator wishes to use to communicate
with the module manager. The range of values is 1 to 4095. The
default value is
1
.
SM Management VID Pass-
through
Specify whether to allow the SM (
Enable
) or the AP (
Disable
) to
control the VLAN settings of the SM. The default value is
Enable
.
Do not set this parameter to
Enable
where both a BAM
release earlier than 2.1 is implemented.
The
Configuration Source
parameter in the AP is set to
BAM
.
This combination causes the SMs to become unmanageable,
until you gain direct access with an override plug and
remove this combination from the AP configuration.
QinQ EtherType
This parameter is the outer S-VLAN Ethertype that may be
configured to interoperate with other networks that use a
different Ethertype than the default.
Active Configuration
When VLAN is enabled in the AP, the Active Configuration
block provides the following details as read-only information in
this tab. In the Motorola fixed wireless broadband IP network,
each device of any type is automatically a permanent member of
VID 1. This facilitates deployment of devices that have VLAN
enabled with those that do not.
Summary of Contents for PMP 450
