Task 5: Configuring security
Chapter 2: Configuration and alignment
2-64
pmp-0050 (May 2012)
Protocol
Selected
Port Filtered (Blocked)
SNMP
Destination Ports 161 TCP and UDP, 162 TCP and UDP
Bootp Client
Source Port 68 UDP
Bootp Server
Source Port 67 UDP
Encrypting downlink broadcasts
An AP can be enabled to encrypt downlink broadcast packets such as the following:
ARP
NetBIOS
broadcast packets containing video data on UDP.
The encryption used is DES for a DES module, and AES for an AES module. Before the Encrypt Downlink
Broadcast feature is enabled on the AP, air link security should be enabled on the AP.
Isolating SMs
In an AP, you can prevent SMs in the sector from directly communicating with each other. In CMMmicro
Release 2.2 or later and the CMM4, you can prevent connected APs from directly communicating with each
other, which prevents SMs that are in different sectors of a cluster from communicating with each other.
In the AP, the
SM Isolation
parameter is available in the General tab of the Configuration web page. In the
drop-down menu for that parameter, you can configure the SM Isolation feature by any of the following
selections:
Disable SM Isolation
(the default selection). This allows full communication between SMs.
Block SM Packets from being forwarded
. This prevents both multicast/broadcast and unicast SM-to-SM
communication.
Block and Forward SM Packets to Backbone
. This not only prevents multicast/broadcast and unicast SM-
to-SM communication but also sends the packets, which otherwise would have been handled SM to SM,
through the Ethernet port of the AP.
In the CMMmicro and the CMM4, SM isolation treatment is the result of how you choose to manage the port-
based VLAN feature of the embedded switch, where you can switch all traffic from any AP to an uplink port
that you specify. However, this is not packet level switching. It is not based on VLAN IDs. See the
VLAN Port
Configuration
parameter in the dedicated user guide that supports the CMM product that you are deploying.
Summary of Contents for PMP 450
