Task 4: Configuring General and Unit
settings
Chapter 2: Configuration and alignment
2-42
pmp-0050 (May 2012)
Table 19
SM PPPoE attributes
Attribute
Meaning
Device Setting
You can temporarily transform an AP into an SM and thereby use
the spectrum analyzer functionality. Otherwise, the selection for this
parameter is
AP
.
Link Speeds
From the drop-down list of options, select the type of link speed for
the Ethernet connection. The default for this parameter is that all
speeds are selected:
Auto 100F/100H/10F/10H
. In this setting, the
two ends of the link automatically negotiate with each other whether
the speed that they will use is 10 Mbps or 100 Mbps and whether the
Ethernet traffic will be full duplex or half duplex. However,
Ethernet links work best when either
both ends are set to the same forced selection
both ends are set to auto-negotiate and both have capability in least
one common speed and traffic type combination.
Configuration Source
See
Setting the Configuration Source
Sync Input
Specify the type of synchronization for this AP to use:
Select
Sync to Received Signal (Power Port)
to set this AP to receive
sync from a connected CMMmicro or CMM4.
Select
Sync to Received Signal (Timing Port)
to set this AP to receive
sync from a connected CMM2, an AP in the cluster, or an SM.
Select
Generate Sync Signal
where the AP does not receive sync, and
no other AP is active within the link range.
Summary of Contents for PMP 450
