PMP 450 Planning Guide
Glossary
Calculation of power density
The following calculation is based on the ANSI IEEE C95.1-1991 method, as that provides a worst case analysis.
Details of the assessment to EN50383:2002 can be provided, if required.
Peak power density in the far field of a radio frequency point source is calculated as follows:
Where:
Is:
S
power density in W/m
2
P
maximum average transmit power capability
of the radio, in W
G
total Tx gain as a factor, converted from dB
d
distance from point source, in m
Rearranging terms to solve for distance yields:
Calculated distances and power compliance margins
shows calculated minimum separation distances, recommended distances and resulting margins for each
frequency band and antenna combination. These are conservative distances that include compliance margins. At
these and greater separation distances, the power density from the RF field is below generally accepted limits for
the general population.
PMP 450 equipment adheres to all applicable EIRP limits for transmit power when operating in MIMO mode.
Separation distances and compliance margins include compensation for both transmitters.
Tx burst – maximum average transmit power in burst (Watt)
P – maximum average transmit power capability of the radio (Watt) (combined transmitters)
G – total transmit gain as a factor, converted from dB
S – power density (W/m
2
)
d – minimum distance from point source (meters)
R – recommended distances (meters)
C – compliance factor
2
4
.
d
G
P
S
π
=
S
G
P
d
.
4
.
π
=
3-14
pmp-0047 (March 2014)
Summary of Contents for PMP 450
