PTP 800 Series User Guide
Task 5: Configuring securit y
phn- 2513_004v000 ( Oct 2012)
6- 29
Configuring AES encryption
To configure AES link encryption (before the link is operational), proceed as follows:
1
Check the capability summary in the Software License Key page to ensure that the
current license key supports AES. If necessary, obtain an access key and generate
a new license key, as described in
Task 3: Installing license keys
2
Select menu option
System, Configuration
. The Installation Configuration page
is displayed (
3
Select the Encryption Algorithm, either ‘AES 128-bit’ or ‘AES 256-bit’. The same
algorithm must be used at both ends of the link.
4
Enter and confirm the encryption key. The key consists of 32 or 64
case-insensitive hexadecimal characters. The same key must be used at both ends
of the link.
5
Select
Submit Updated System Configuration
. The reboot confirmation dialog
is displayed:
6
Select
Reboot Wireless Unit
and then
OK
to confirm.
Summary of Contents for PTP 800 Series
