Task 8: Set t ing up SNMP agent
Chapt er 6: Configurat ion and alignm ent
6- 86
phn- 2513_004v000 ( Oct 2012)
Configuring SNMPv1/2c agent
Perform this task to enable the system to generate Simple Network Management Protocol
version 1 or 2c (SNMPv1 or SNMPv2c) traps.
Start SNMP wizard
To start the SNMP wizard, select menu option
Management, SNMP
. The Current SNMP
Summary page is displayed (
). Review the summary. If any updates are
required, select
Continue to SNMP Wizard
.
Step 1: SNMP Configuration (for SNMPv1/2c)
The Step 1: SNMP Configuration page is displayed. Set SNMP State to ‘Enabled’ and set
SNMP Version to ‘v1/2c’. The page is redisplayed with SNMPv1/2c attributes (
Update the attributes (
), then select
Next
.
Figu r e 1 5 9
St ep 1: SNMP Configurat ion page ( for SNMPv1/ 2c)
Ta ble 2 4 0
St ep 1: SNMP Configurat ion at t ribut es ( for SNMPv1/ 2c)
At t r ibu t e
M e a n in g
SNMP State
‘Enabled’ means that the system will generate SNMP traps.
SNMP Access
Control
‘Enabled’ means that access to SNMP is controlled via IP
address. Up to three IP addresses may be entered.
SNMP Version
SNMP protocol version v1/2c or v3.
Summary of Contents for PTP 800 Series
