20
Dynamic Range Control
This setting controls the dynamic range of Dolby Digital or DTS movie
soundtracks by compressing the dynamics in four stages to limit the
difference in level between loud and quiet passages in the movie.
This can be a useful feature when watching movies late at night for
instance. Four settings are possible:
DRC=0/4 No Compression (normal full dynamic range playback)
DRC=1/4
DRC=2/4
DRC=3/4
DRC=4/4 Greatest Compression (reduced dynamic range playback)
DRC can be accessed by the Dynamic button on the remote, DRC=0/4
etc is displayed, pressing the button again moves to the next setting.
When finished make no adjustment for a few seconds and the 540R v3
will save the settings and exit the menu.
Note: DRC only works for Dolby Digital or DTS source material which
supports this feature.
Using the Tuner
1. Press the
Tuner FM/AM
button on the front panel or remote control
to select Tuner mode.
2. Press the
Tuner FM/AM
button again to select FM or AM if desired.
3. Press the
Mode/Store
button on the front panel (or
Mode
button on
the remote control) to select automatic tuning, manual tuning or
preset mode.
4. Press the
and
Tuning -
buttons (or the left and right arrow
buttons on the remote) to select the station you want to listen to.
In automatic tuning mode the unit scans to the next strong station. In
manual tuning mode the user can step manually through the
frequencies. In preset mode the unit cycles through the presets only.
Two FM modes are available, stereo and mono - Press the
Stereo Mono
button on the remote to alternate between Stereo mode and Mono
mode. If the
Display
button is pressed, the RDS station names of FM
stations will be displayed if available.
Storing stations
1. Tune in a station you wish to store as explained previously.
2. Press and hold the
Mode/Store
button (or
Mode
button on the
remote) for 5 seconds to bring up the ‘MEM’ icon.
3. Use the
/-
buttons to select a preset station number (1-15).
The station number will be displayed on the screen.
4. Press the
Mode/Store
button (or
Mode
button on the remote) to
memorise, while the ‘MEM’ icon is still flashing.
Radio Data Systems (RDS)
RDS is a method for the transmission of additional information from
local radio stations. It is only available in FM mode. RDS will only work if
the local broadcasting stations have RDS transmission and the signal is
strong enough.
Press the
Display
button on the remote and go through the displayed
functions. There are functions for PS, PTY, CT and RT:
PS (Station Name) - current station name will be shown
PTY (Program Type) - current name type of the program will be shown
CT (Clock/Time) - current time from Radio Station will be displayed.
Note: Clock/Time will be only transmitted from local radio station once
a minute. If the Clock - Time is not available the message ‘NO CT’ will
appear briefly on the display.
RT (Radiotext) - some Text messages will be shown.
Program Type Search (PTY)
1. Press the
PTY
button on remote control, ‘PTY SELECT’ will flash on the
display.
2. Press
/-
to choose the program type, for example NEWS or
SPORT.
3. Press the
PTY
button again once you have chosen the program type.
When the selected type of program is tuned in, it will stop searching,
otherwise, PTY Search will timeout after approximately 30 seconds.
Auto Program Search (APS)
1. Press the
Tuner FM/AM
button to select the AM or FM band.
2. Press the
APS
button on the remote to begin the automatic program
search through available stations. The searched stations will be
memorised in the respective band memory (maximum of 15
stations).
Operating instructions continued
