Cambridge Audio CXN V2, User Manual

3

CX

N V2

3

For your own safety please read the following important safety instructions 

carefully before attempting to connect this unit to the mains
power supply. They will also enable you to get the best performance from 

and prolong the life of the unit:
  1. Read these instructions.
  2. Keep these instructions.
  3. Heed all warnings.
  4. Follow all instructions.
  5. Do not use this apparatus near water.
  6. Clean only with a dry cloth.
  7.  Do not block any ventilation openings. Install in accordance with the 

manufacturer’s instructions.

  8.  Do not install near any heat sources such as radiators, heat registers, 

stoves, or other apparatus (including amplifiers) that produce heat.

  9.  Do not defeat the safety purpose of the polarized or grounding-type 

plug. A polarized plug has two blades with one wider than the other. 

A grounding-type plug has two blades and a third grounding prong. 

The wide blade or the third prong are provided for your safety. If the 

provided plug does not fit into your outlet, consult an electrician for 

replacement of the obsolete outlet.

10.  Protect the power cord from being walked on or pinched, particularly 

at plugs, convenience receptacles and the point where they exit from 

the apparatus.

11. Only use attachments/accessories specified by the manufacturer.
12.  Use with only the cart, stand, tripod, bracket, or table 

specified by the manufacturer, or sold with the apparatus. 

When a cart is used, use caution when moving the cart/ 

apparatus combination to avoid injury from tip-over.

13.  Unplug this apparatus during lightning storms or when unused for 

long periods of time.

14.  Refer all servicing to qualified service personnel. Servicing is required 

when the apparatus has been damaged in any way, such as the power-

supply cord or plug having been damaged, liquid has been spilled or 

objects have fallen into the apparatus, the apparatus has been exposed 

to rain or moisture, does not operate normally, or has been dropped.

WARNING

–  To reduce the risk of fire or electric shock, do not expose this unit 

to rain or moisture.

–  Batteries (battery pack or batteries installed) shall not be exposed to 

excessive heat such as sunshine, fire or the like.

The unit is of Class 1 construction and must be connected to a mains 

socket outlet with a protective earthing connection.
The unit must be installed in a manner that makes disconnection of the 

mains plug from the mains socket outlet (or appliance connector from the 

rear of the unit) possible. Where the mains plug is used as the disconnect 

device, the disconnect device shall remain readily operable. Only use the 

mains cord supplied with this unit.
Please ensure there is ample ventilation (at least 10cm clearance all 

round). Do not put any objects on top of this unit. Do not situate it on 

a rug or other soft surface and do not obstruct any air inlets or outlet 

grilles. Do not cover the ventilation grilles with items such as newspapers, 

tablecloths, curtains, etc.
This unit must not be used near water or exposed to dripping or splashing 

water or other liquids. No objects filled with liquid, such as vases, shall be 

placed on the unit.

Important safety instructions

The lightning flash with the arrowhead symbol within an equilateral 

triangle is intended to alert the user to the presence of un-insulated 

‘dangerous voltage’ within the product’s enclosure that may be of sufficient 

magnitude to constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is intended to alert the 

user to the presence of important operating and maintenance instructions 

in the service literature relevant to this appliance.

WEEE SYMBOL

The crossed-out wheeled bin is the European Union symbol 

for indicating separate collection for electrical and electronic 

equipment. This product contains electrical and electronic 

equipment which should be reused, recycled or recovered and 

should not be disposed of with unsorted regular waste. Please 

return the unit or contact the authorised dealer from whom 

you purchased this product for more information.

CE MARK

This product complies with European Low Voltage (2014/35/

EU), Electromagnetic Compatibility (2014/30/EU) and 

Environmentally-friendly design of Energy-related Products (2009/125/EC) 

Directives when used and installed according to this instruction manual. 

For continued compliance only Cambridge Audio accessories should be 

used with this product and servicing must be referred to qualified service 

personnel.

RCM (REGULATORY COMPLIANCE MARK)

This product meets the Safety, EMC and Radio 

Communications  requirements of the ERAC and ACMA.  

CU-TR MARK

This product meets Russia, Byelorussia and Kazakhstan 

electronic safety approvals.

VENTILATION

IMPORTANT

 – The unit will become hot when in use. Do not stack 

multiple units on top of each other. Do not place in an enclosed area such 

as a bookcase or in a cabinet without sufficient ventilation. 
Ensure that small objects do not fall through any ventilation grille. If this 

happens, switch off immediately, disconnect from the mains supply and 

contact your dealer for advice.

POSITIONING

Choose the installation location carefully. Avoid placing it in direct 

sunlight or close to a source of heat. No naked flame sources, such as 

lighted candles, should be placed on the unit. Also avoid locations subject 

to vibration and excessive dust, cold or moisture. The unit can be used in 

a moderate climate. 
This unit must be installed on a sturdy, level surface. Do not place in a 

sealed area such as a bookcase or in a cabinet. Do not place the unit on 

an unstable surface or shelf. The unit may fall, causing serious injury to a 

child or adult as well as serious damage to the product. Do not place other 

equipment on top of the unit.
Due to stray magnetic fields, turntables or CRT TVs should not be located 

nearby due to possible interference.
Electronic audio components have a running in period of around a week (if 

used several hours per day). This will allow the new components to settle 

down and the sonic properties will improve over this time.

POWER SOURCES 

the marking label. If you are not sure of the type of power-supply to your 

home, consult your product dealer or local power company.
This unit can be left in Standby mode when not in use and will draw <0.5W 

in this state. To turn the unit off, unplug it from the mains socket.