Aux input
Successful pairing will be signalled by a ‘beep’ from the unit and the
LED will stop flashing.
Press the button to select the Aux input.
Extend the FM aerial for best reception.
To switch to the FM Radio
press one of the preset
buttons 1-3.
Press and hold the or
buttons to scan for an
available station (a short press
will change the frequency step by step).
Storing and using FM presets
Pressing and holding preset buttons 1-3 will store
the current radio station.
A short press on buttons 1-3 will recall the stored station.
Pairing a second device
Radio
The charging LED will indicate orange whilst charging and
green when fully charged.
Press and hold the power button on the top of the unit for two
seconds to turn it on.
Battery Safety
Your Go Radio contains a high performance battery and charging system
that is designed to work in temperatures that do not exceed 50°C (122°F).
Leaving this product in an automobile where temperatures may exceed this
limit may result in permanent battery damage, fire or explosion. Do not leave
your product in any location where temperatures may exceed this limit.
Please recharge the battery every two months to maintain the battery in
optimal condition.
Bluetooth set-up
Press the button to select the Bluetooth input.
To pair a different device, press and hold the button for two seconds to
enter pairing mode and pair your Bluetooth device as described in the
Bluetooth instructions.
1.
2.
Press and hold the button for two seconds to enter Bluetooth pairing
mode. The flashing blue LED, indicates pairing mode.
Enable Bluetooth connectivity on your Bluetooth device (eg. phone, tablet
etc) and pair with the Go Radio (you may need to consult your phone or
tablet operating instructions).
Pairing Your Device Manually
User manual
GO RADIO
PORTABLE BLUETOOTH & FM SPEAKER
To talk to us, call +44 (0)203 514 1521 (UK Local)
or 1-877-357-8204 (USA)
Auto power down
To save power, your Go Radio will automatically turn off after 30
minutes if no music is playing. Press the power button to turn the Go
Radio back on.
Low battery warning
A flashing red LED indicates that the battery is too low and the Go
Radio will enter a standby mode where no music can be played. This
LED will continue flashing for 30 minutes after which the Go Radio will
turn off.
TOP TIPS
!
USB Charging
The Go Radio can be used to charge compatible mobile devices. If the
charging adaptor is not connected this will drain the battery.
Important !
Connect the charging adaptor to the Go Radio and charge for
4 hours before first use.
You may need to ensure Bluetooth is enabled on
your device.
Touch your NFC device against the logo on
top of the Go Radio.
Go Radio will enter automatic pairing mode and
‘Go Radio’ should appear on your device.
NFC
1.
2.
If your Bluetooth device is NFC enabled
