Assemble the Cab
NOTE:
If you prefer to install your landing frames now and use the cab floor as a work
platform, proceed to landing installation
Procedure:
•
Move the sling to allow access below the elevator to the floor of the cab, and to the
inside the elevator cab. Typically, this will be the lowest floor.
Cab with 3 full walls and one gate and brackets
•
Move the wall labelled “TOP BACK” into the hoistway and place it on the floor across
from the opening
•
Line up the holes in the floor with the holes in the wall and bolt in place with the
hardware provided
•
Bring each full wall into the hoistway and position it according to the label on the back
of the wall and secure into place with the hardware provided
•
Bolt the adjoining walls hand tight in order to stabilize the walls
•
If you have a return wall or a return wall with a header attached, set in place in the
opening and bolt it in place through the floor and to the adjoining wall at the bottom
•
Move the cab, if necessary, in order to access the ceiling and inside the cab at the same
time
•
Bring the ceiling into the shaft and set it on the walls
•
Bolt the ceiling to each wall hand tight with 4 bolts provided
Cab with two openings across from each other (known as a through cab).
•
Bring each full wall into the hoistway and position it according to the label on the back
of the wall
•
Bolt each wall in place through the floor with the bolts provided
•
If you have a return wall, set it in place in the opening and bolt it in place through the
floor and to the adjoining wall
•
Move the cab (if necessary), in order to access the ceiling and inside the cab at the same
time
•
Bring the ceiling into the shaft and set it on the 2 walls
•
Bolt the ceiling to each wall hand tight with bolts provided
•
Install the remaining bolts between walls
Summary of Contents for JOURNEY LU
