Page | 16
Lighting the Appliance
GENERAL RULES
Do not leave the appliance unattended while cooking!
-
Make sure the appliance has been leak tested and is properly located.
-
Check that each burner ring is properly located over each valve orifice.
-
Light the burner using the instructions provided in this manual.
-
Adjust heat settings to your desired cooking temperature.
-
Allow appliance to cool down, wipe off any splatters or grease and clean as needed.
-
Do not put a cover on the appliance while it is still hot as it could start a fire.
NOTE:
If, for some reason, the appliance fails to light, burners can be lit with a gas lighter.
NOTE: To manually light gas burner with a gas lighter
, make sure the appliance has been leak tested and
burners are properly located. Remove the cooking grids from the burner you wish to light. Insert a long-necked
gas lighter, placing it near to burner ports. Press in the closest burner
knob and rotate left to “HIGH” setting to
release gas. Turn on gas lighter, burner should light immediately. Place back the cooking grids and adjust burners
to desired cooking temperature.
Lighting Instructions
Single and Double Burner:
1. Remove the stainless steel cover.
2. Ensure
controls knobs are in “OFF” position; turn on the gas supply valve.
3. Press and turn the control knob to HIGH position 3-5 seconds to light burner.
4. If ignition does not occur in 5 seconds, turn the control
knob to “OFF”, wait 5 minutes to allow gas to dissipate
and repeat the lighting procedure.
5. To light the other burner, press and turn control knob one by one counterclockwise to HIGH position and adjust
to desired cooking temperature.
Power Burner:
1. Remove the stainless steel cover.
2.
Ensuring controls knobs are in “OFF” position; turn on the gas supply valve.
3. Press and turn the RIGHT control knob to HIGH position 3-5 seconds to light inner burner.
4. Press and turn the LEFT control knob to HIGH position 3-5 seconds to light outer burner.
5. If ignition does not occur in 5 seconds, turn the control
knob to “OFF”, wait 5 minutes to allow gas to dissipate
and repeat the lighting procedure.
6. Adjust to desired cooking temperature.
WARNING:
DO NOT use appliance if gas odor is present. DO NOT stand with head, body, or arms over the appliance when lighting.
Inspect the hose before using the appliance. If there is excessive abrasion or wear, or if the hose is cut, it must be replaced
prior to the appliance being put into operation. The replacement hose assembly shall be that specified by the manufacturer.
Ensure the area around the appliance is clear of flammable substances such as gasoline, yard debris, wood, etc.
Ensure there is no blockage of the airflow through the vent space located below the face of the unit.
DANGER:
Failure to open the lid while igniting the burner, or not waiting 5 minutes to allow the gas to clear if the burner does not light
before retrying may result in an explosive flame-up which can cause serious bodily injury or death.
