ModIT-Boss
Página 8 de 24
3.3. Conexión a la red eléctrica
Make sure you adhere to local safety regulations, connect the power cable to the socket and
switch the power supply on. The hub is now ready to charge the attached devices.
Periodic inspections should be made to power supply cables and any USB cables for any signs of
damage. If any damage is found, replace the damaged cord before further use.
Tenga en cuenta que las especificaciones USB exigen un suministro de corriente de carga
mínima de 100 mA durante la transferencia de datos. Como se indicaba anteriormente, si el
dispositivo conectado tiene un puerto CDP compatible con BC1.2, el dispositivo puede consumir
hasta mientras se transfieren datos.
3.4. Cargando
Your ModIT-Boss will allow your device to charge at the maximum rate possible up to . The way
that charging takes place is the ModIT-Boss will provide the device with a capability to charge
and the devices USB charging controller will determine the maximum amount of charge it
wants to draw down.
3.5. Cables
Some USB cables are data transfer only, and some are power delivery only. There are also
options that can handle both tasks. Be sure to verify a cable’s abilities before purchasing it and
select a cable which can handle the speeds and power transfer that you require. We would
advice using the cable that was provided with the device to connect to our hubs.
3.6. Registro
Puede registrar su producto en
www.cambrionix.com/product-registration
