OEM-U8S
Page 23 of 43
Setting name
Description
Default
value
Attach
Threshold
(mA)
The attach threshold is the device current (mA) level at which the
hub can determine that a device (iPhone etc.) has been attached
to a port. The attach threshold may need to be increased if the
device (iPhone etc.) is connected to a Cambrionix port with a
cable which includes an LED or other electronics. It may also need
to be increased if you are using a device (iPhone etc.) with a 3rd
party sled/holder/case (such as a barcode scanner or battery
pack) which contains electronics or charging pass-through
10
Charged
Threshold
(mA)
The charged threshold is used to determine if the device is
probably charged. If the drawn power goes below this mark for 2
minutes, then we set a charged flag
100
Temperature
Max (°C)
Sets Maximum temperature before the shut-down of ports
70
Remap Ports
Change the ordering of the ports from the default
Sequential
order
Default
Profiles
Change the default profile for specific ports. Use 0 for default
operation
0
Ports On
Configure which ports to be always powered regardless of attach
status. This must only be used in conjunction with a default
profile
Off
Sync Charge
Enable CDP* on a per port basis
On
Alt Sync
Charge
Enable alternative method CDP* to support some hardware. This
has no effect if Sync Charge for that port is disabled.
On
Display Mode
Change display mode for hubs that have extended LEDs
Current
(mA)
Flags
Change various flags
None
selected
Stagger (ms)
Introduce a delay between ports turning on when either host is
detected or mode is switched to Sync. 0-9999ms
3000
Stagger_offset
(ms)
An additional delay to add before starting the staggered process.
0-9999ms
0
