Step 3: Install Casters
1
2
3
4
5
It is not necessary to
remove small rubber
band before installing.
Lay rack down on 1 end.
It is not necessary to remove small
rubber band around plastic parts
on caster stem.
Hold plastic parts together on caster
stem and insert into post opening.
Mallet caster into bottom of post.
Push brake down to lock caster.
Turn caster clockwise (to the right)
approximately 1/4 turn until caster
stops. Release brake.
CAUTION! DO NOT OVER-TIGHTEN!
1
2
3
4
5
Lay rack down on 1 end.
It is not necessary to remove small
rubber band around plastic parts
on caster stem.
Hold plastic parts together on
caster stem. While holding together,
hold the metal ring at the top of the
caster and turn counter clockwise
until tight. Then, insert into
post opening.
Mallet caster into bottom of post.
1
2
3
4
For Zinc Plated Casters
For Premium Plastic Casters
