the bearing to ensure that new grease is
being distributed throughout the bearing
and not just purging past the seals. Inject
the recommended amount divided by the
number of stops during each index for one
full revolution of the table.
WARNING
CAMCO’s Heavy Duty "E" Series Index Drives
cannot be "hand cranked" when completely
assembled, i.e. with follower wheel installed.
During some portions of repair, the motor
drive package is used to rotate the input shaft
and follower wheel. Some means for running
the motor at extremely low speeds is manda-
tory. Use extreme caution when operating the
motor during repairs.
HOW TO ORDER PARTS:
Please refer to the parts lists shown in this
Service Manual. These parts lists are for stan-
dard Index Drives. If you feel your drive is
nonstandard or you are in doubt, you should
contact CAMCO Customer Service at (847)
459-5200 and request a Bill of Materials for
your specific unit based on its serial number.
Alternatively, contact your local CAMCO Sales
Representative. A complete list of CAMCO
Sales Offices is available on CAMCO’s web
site, (http://www.camcoindex.com). CAMCO
maintains hard copy records on all units for a
period of seven (7) years.
You may order parts per the standard Bill of
Material even if your unit is nonstandard.
CAMCO’s Customer Service Representative
will review the closed order file based on the
following information and supply you with the
correct part.
REQUIRED INFORMATION:
1. Original purchase order number
(if available)
2. Customer name
(original purchaser of drive )
3. Model number (located on name plate)
4. Serial number (located on name plate)
(essential when ordering parts)
5. Approximate date of purchase
TO ORDER PARTS:
Contact CAMCO’s "Order Entry Department"
Wheeling, Illinois, Phone (847) 459-5200 or
FAX (847) 459-3064,
E-mail: mktg@camcoindex.com,
or Internet: http://www.camcoindex.com
Describe the parts required and the 14 digit
part number as listed in the Standard Bill of
Materials or a Special Bill of Materials pertain-
ing to your unit. State if you are using a
Standard or Special Bill of Materials.
Give as much of the above required
information as possible.
ON WARRANTY:
CAMCO will send replacement parts freight
prepaid via the most practical means.
CAMCO will issue a "Returned Material
Authorization Number" (RMA#) for the return
of defective parts for inspection. CAMCO will
invoice customer for repair parts. When
inspection of returned parts has been
completed and determined to be a warranty
problem, CAMCO will then issue a credit to
the customer for repair parts and freight
charges.
ON NON-WARRANTY:
Replacement or spare parts, with approved
credit, are F.O.B. our plant Wheeling, Illinois.
20
Summary of Contents for HEAVY DUTY SERIES INDEX DRIVES 1150E
Page 22: ...21 950E 1150E 1550E 2050E END VIEW SIDE VIEW...
Page 27: ...USA 5 00 0079...
