Page 3 of 5
CM-550SK-V3 WATERPROOF KEYPAD
INSTALLATION INSTRUCTIONS
Wiegand Out to Access System (Card/PIN stored in Access System)
Wiegand Output Mode
Step 1) 03 0 #
(Enables data lines to be connected to an Access Controller)
Facility Code
Step 2) 60 (0-255) # (Must match Access Controller)
Set D0 & D1 Output
Step 3) 61 0 #
(Enables D0 & D1 Wiegand Output data format)
Set Output Bit Length
Step 4) 62 (26-66) # (Example of 26 bit: 62 26 #)
PIN Output (5 Digits)
Step 5) 64 4 # (1–5-digit key + # key buffered output)
Set 4/8 Bit Burst Output
Step 6) 64 (0, 2) # (0 = 4 bit burst, 2 = 8 bit burst, confirm with
Access manufacturer)
Alarm Configuration (D.H.O/F.E.)
Door Held Open (D.H.O.)
35 (0-99) # The set time starts once the door is unlocked, then
it will generate the alarm if the door is not closed. Timing is in
minutes. Closing the door resets the alarm.
Door Forced Open (F.E.)
40 (0-99) # Door opened with no valid PIN or Card
immediately triggers an alarm.
Timing is in minutes. Master Programming Code resets alarm.
5. WIRING CONNECTIONS FOR VDC OR VAC POWER
The CM-550SK V3 keypad can be powered by either VDC or VAC power within a range of 10V – 28V.
When wiring for
VDC power use the red wire for positive and the black wire for ground.
When wiring for
VAC power use the red wire (AC1) to one VAC wire and light green wire (AC2) to the other VAC wire.
Note: Confirm you are using the light green wire and not the dark green Data 0 wire.
Sta
nd Alone
Acce
ss Control
Ke
ypad
AC2
AC1
D_IN
OPEN
GND
NO
COM
NC
Light Green
RED
BROWN
YELLOW
BLACK
BLUE
PURPLE
ORANGE
Camden Model: CM-550SK V3
Sta
nd Alone
Acce
ss Control
Ke
ypad
AC2
AC1
D_IN
OPEN
GND
NO
COM
NC
Light Green
RED
BROWN
YELLOW
BLACK
BLUE
PURPLE
ORANGE
Camden Model: CM-550SK V3
Power
Supply
DC
10-28V
+ve
-ve
Not Used
Relay contacts
To trigger door
strike or
Maglock
Power
Supply
AC
10-28V
Not Used
Relay contacts
To trigger door
strike or
Maglock
Camden Model: CX-TRP-612DC
Camden Model: CX-TRP-4016
Wiring for DC Power (AC1 &
g
n
ir
i
W
)
D
N
G
for AC Power (AC1 & AC2)
Note: Connect corresponding power as shown above to prevent damage to the keypad.
Delete by ID# (Card or PIN)
22 ID# # Multiple Deletes 22 ID# #, ID# #, ID# #
Unlock Duration
34 (1-999 seconds) #
