Call: 1.877.226.3369 / 905.366.3377
Visit: www.camdencontrols.com
Opening New Doors to
Innovation, Quality and Support!
CX-ED1259L ‘RIM’ Electric Strike
INSTALLATION INSTRUCTIONS
File: CX-ED1259L-Manual-R4.indd
Revision: 15/07/2019
Part No.: 40-82B205
Page 8 of 8
Consideration of the free
movement of the exit device
latch and the keeper (jaws)
of the RIM strike.
Ensure the latch of the exit
device and the keeper (jaws)
of the electric strike have free
and easy movement to operate
together, with a minimum of
friction. In this, a small amount
of silicone lubricate on both the latch and jaws of the strike
will improve the operation… but please be careful not to over
spray.
Consideration for a
professionally finished retrofit
installation.
Replacing electric strikes used with
cylindrical or mortise locksets,
with an exit device and RIM strike,
will leave holes in the door and
door frame that must be filled or
covered. Cover or plug holes and
check that new cover plates are
flush with the frame… and will not interfere with the RIM strike.
Cover plate
flush with
frame
Summary
Adherence with the recommendations of this guide will avoid the
most common problems associated with the installation of RIM
strikes. If you require additional assistance, please contact our
Technical Support department by phone at 1 877 226-2269 or
email support@camdencontrols.com.
