CX-ED1410 ‘Universal’ Fire Electric Strike
1. Prepare the door jamb as per the appropriate drawing.
2. Install mounting brackets to jamb using M5x12 screws
and pressed metal nuts. Do not tighten.
3. Spacers are used to assure flush final assembly of
faceplate into jamb. Add one or more spacers between
jamb and mounting bracket when face plate extends
beyond the jamb. When the faceplate sits inside the
jamb, spacers must be added between the mounting
bracket & the lip bracket. Make sure the clearance hole in
the spacer aligns with the hole in mounting bracket.
4. Connect wires coming from the low voltage side of the
transformer to wires (black) from strike.
5. Install electric strike jamb by attaching with # 10-32
screws and lockwashers.
6. Securely tighten the M5x12 screws holding the mounting
brackets to jamb.
4. Installation
Mounting Bracket (2pcs)
Drill & Countersink For
M5 Flat-Head Screw (2pcs)
Pressed Metal Nut
M5x12
Flat-Head
Screw (4pcs)
Horizontal
Centerline
M5x12
Flat-Head
Screw (2pcs)
Jamb
Vertical Centerline
Vertical Centerline
Centerline
Jamb
126
105
37
48
35
86
126
155
86
35
37
48
Page 2 of 3
Note: The products are intended to be installed in
accordance with the installation wiring diagram, mechanical
assembly drawings provided with each product, the local
authority having jurisdiction (AHJ) and the National Electric
Code, NFPA 70. When installed in fail secure mode, the
local authority shall be consulted with regard to the use of
possible panic hardware to allow emergency exit from the
secure area.
The electric door strike shall be installed in such a way
and in such location so as to not impair the operation of
an emergency exit device or panic hardware mounted on
the door.