CX-EPD 2850L Pre-Load Electric Strikes Installation Instructions and Technical Support
When installing an EZ-‐FIT electric strike, the things to be aware of are:
1)
The edge of the door should be at a 90-‐degree angle of the strike plate, and parallel with the edge of the frame.
If this is not the case, use the provided “support kit” to compensate as shown below
Connection
Latch Monitoring Output
Built-‐in latch monitoring feature wired to access
control system.
Power Input
12/24V AC/DC
Using a multimeter, confirm that you have the correct
output voltage at the power supply.
Using a multimeter, confirm that you have the correct
input voltage at the strike.
+/-‐ doesn’t matter!
EZ-‐Fit Strike Installation
