CV-500PPK-V.2
Installation Instructions
www.camdencontrols.com
Toll Free: 1.877.226.3369
File: CV-500PPK-V.2_NF-Man_Rev1.doc
Revised: March 8, 2011
Part No.: 40-82B131
5502 Timberlea Blvd.,
Mississauga, ON Canada L4W 2T7
5. To cancel the card and the PIN code enter the 6 digit number of the card and press * to confirm or present the
card to cancel. It is not necessary to press the * when presenting the card. 1 audible beep is emitted and the LED
flashes green and red.
6. Press # to exit from the programming mode. 6 beeps confirm the reader is in standby mode.
*
7
Enter the last 6 digits of the card code
1 Beep
Green
LED
flashing
*
#
1 Beep Green
and Red LED
flashing
Present card to cancel
OR
Cancel Group of Card and PIN Code (card or card code)
1. Press
*.
2. Enter the 6 digit master code (for the first use, the master code default is 000000).
3. Press * or present the Master Card.6 audible beeps are emitted and the LED flashes green and red to confirm
entry into programming mode.
4. Press 8, then * to enter inot the cancel group of card + Pin code menu. 1 audible beep is emitted and the LED
flashes green.
5. Enter the number of cards to cancel to a maximum of 99 Cards and Pin codes.
6. Press *. 1 audible beep is emitted and the LED stops flashing.
7. Present the first card from the sequential card group in front of the CV-500PPk-V.2 reader. 1 beep is emitted and
the LED flashes green and red. Or enter the last 6 digit code (decimal number) of the first card from the
sequential card group and press*. 1 audible beep is emitted and the LED flashes green and red.
8. Press # to exit from the programming mode. 6 beeps confirm the reader is in standby mode.
Note: The card and Pin code programming done by the CV-500PPK-v.2 is using an incremental method.
*
8
No. of
Cards 00-99
1 Beep
Green
LED
flashing
*
#
1 Beep Green
and Red LED
flashing
Present 1st
sequential card of
the group
Present 1st
sequential card of
the group
*
1 Beep
Green
LED
