#!.#%,,)!54/-!4)#)
#!.#%,,)!54/-!4)#)
CAME
TSP00
LT001
MEMORY ROLL
P
age
1
5
15
-
Manual code:
1
1
9
G
3
2
6
5
119G3265
ver
.
2
03/2014
© CAME cancelli automatici s.p.a. - The data and information pr
ovided in this manual ar
e subject to change at any time withou
t prior notice by CAME C
ancelli Automatici S.p.a.
ENGLISH
The R700 decoder cards control the turnstile with the sensors (TSP00/LT001) and the
to save and load all the settings
including users stored on another card.
For proper operation, before inserting any plug-in card (e.g.: AF, R700), the LINE VOLTAGE MUST BE REMOVED and any batteries discon-
nected.
Decoder card
Wait 10 seconds after powering before attempting any operation
Functions can be programmed using the push-button panel.
All unused N.C. contacts must be shorted.
In order to use the programming, the traffic light with display must always be installed on the turnstile.
Before programming, read the instructions carefully. Follow the subsequent instructions in the order otherwise the programming will not
be successful.
PROGRAMMING:
The
key is used to
• enter the programming mode
• enter the individual menus
• confirm/store the set value.
The
keys are used to:
• move from one menu item to the next
• increase or decrease a value
The
key is used to exit the menu and cancel
the changes.
A flashing display dot means
that the Master card has not been
created yet.
Display that shows the functions and
settings assigned using the programming
keys.
