19
-
FA01688M4A
- 05/2022 - © CAME S.p.A. - -
Installation
Do not install radio devices less than 4 meters apart.
Place the antenna as high up as possible from the ground, well away from any metal or reinforced-concrete structures.
B
Fix the module to the DIN rails, where present on the operator.
The module can also be installed outdoors, provided it is fastened inside a case with a protection rating of at least IP44.
The device must always be installed well away from metal surfaces and objects. In any case, the control board must not
be fi tted inside metal containers.
Electrical connections
Before making any connections, YOU MUST DISCONNECT THE MAINS POWER.
If the device is not powered by a Came panel, ensure that the power supply has current not greater than 1A.
Where the device is connected to a CAME control panel equipped with CRP via terminal A-B-GND, power the module only
from terminals 2-10 on the panel itself.
Cable length
Section
Cable type
a
PVC FROR 2 x 0,5
c
UTP CAT5 - AWG24
Section
Maximum section length
a
3 m
c
1000 m
